Home CRAFT IDEAS How to make flower garden from bottle

How to make flower garden from bottle


How to make flower garden from bottle
Hi all, everyone !!! Long time my country was not … all summer long lived in the country, and there was not an Internet (((but there was no craft could not have done))) in their spare time, I made a vegetable garden here are the flowers.


wove cobweb, spider landed))) tried to decorate it like an old log wall …


The base of the flower. If interested, I have the flower in a similar


here’s a ball-flowered))) if it is painted in white color, you get another kind of dandelion


but the spider closer


disassembled trash on the ground and spread out around flowers grass clippings, it was better …


And here is another flower, that’s it, and show how these flowers do …





We need 24 plast.butylki +1 bottle base (I have a bottle of – under the adhesive), 2 green bottles, colored adhesive tape (blue, green and orange), scissors, a screwdriver and a thick twig to the stem.
In 16 bottles must be cut bedplate and paste over all the blue tape. At 8 bottles and cut the bottom of a neck and the middle of a paste over orange tape and cut into 2 halves. We cut the neck of the blue, but also the middle of a cut in half, as in the photo. And each half cut into thin strips before reaching the edge of 3-4cm.


The remaining 16 blue necks, they also cut into strips and the ends of the scissors a little twirl.
On one detail flower we need: 1 blue neck, 1 blue and 1 half bottle of orange, but you can do the whole flower monotonous.


And we begin to collect flower … first take the orange half and begin to fold rolls. Please note petals she should be folded outward, not inward.


Tighten, and it starts to become blue one half twist.


and the whole roll of insert into the neck. No glue is not necessary, everything is very durable.


turned here is such a flower. Results of these flowers will turn 16 pcs. One upstairs and the other side.


Here is a handful))) then not all)


For the base, I took a bottle of PVA glue, colored blue. On the cover of the hole made for the trunk.


Use the screwdriver to fasten caps on them has tightened flowers.


That’s got such a flower, but without the lower series (not enough bottles).


Now do the leaves: a bottle cut into three pieces along. And collect the flower: the trunk wrapped in green tape is inserted into the bottle, and dress the leaves from the bottom …


And that was not the lone flower has decided to make it vyunochek))) to cut off the neck of the bottle and the bedplate and midway painted in yellow color and also cut into fringe …


Putting the tip of the glue rolls and green tape.


Take one end of the wire and wrapped with orange tape


and inserted into the flower …


and until the end of the wire wrapped with green tape.


received such little vyunochki … more to do much the same: first the neck at the green bottle, but with a cut mouth, then another the neck, the neck strung one to another (hopefully clear written))) and then glued at the bottom of a bottle of white. I do not remember how attached the core, made in the spring))) you have to look, and then I’ll write …



While the flower looks like …


Now do sepal at the blue flower. Take the green bottle, cut off the bottom of a and cut into 3 parts. Now, each part should be cut fringe, but we must not be cut straight and at an acute angle


get here is a sepal, we will put it on the flower


that’s ready to go!


The result here is a flower))) After that, I took another two such flower))) In my opinion it turns out unusual and not immediately possible to understand that it is made out of bottles.


Courtesy: stranamasterov.ru